ASE 4

It features four band graphic equalizer - Bass, Middle, Treble & Presence - with Master volume and Low Battery check LED. Using metal case could eliminate the noise and the slim body case could be fit in any size of guitars.

ASE 4  features :
 - Bass, Middle, Treble, Presence Controls
 - Master Volume, Low  Battery check LED

ASE-N  features :
 - Bass, Middle, Treble, Presence Controls
 - Master Volume, Low  Battery check LED
 - Notch switch

DIMENSION :  W 50 X H 90 X D 40 (mm)

ASE-N       ASE 4 with Notch filter

Technical Specifications

Nominal input level:
Frequency Response:
Input Impedance:
Output Impedance:
Power Supply:
Battery Life:
Bass control range:
Middle control range
Treble control range
Presence control range:
Low Battery:
Current Drain:
Input Jack:
Output Jack

-20 dBV
20 Hz - 20 kHz
10 MOhm
10 kOhm
9 V Alkaline Battery
over 1800 hours
Boost and Cut 12 dB 80 Hz, 570 mVp-p
Boost and Cut 12 dB 800 Hz, 490 mVp-p
Boost and Cut 12 dB 3 kHz, 500 mVp-p
Boost and Cut 12 dB 15 kHz, 500 mVp-p
Low  Battery check at 4.5 V ~ 5.5 V
Less than 0.3 mA
2.5 mm Mono Jack
1/4" Phone Jack

ASE-BL   Magnetic + Piezo Blender EQ

ASE-BL is the Blender EQ for blending the acoustic sounds of Piezo pickup and Magnetic pickup.
It features 3 Band EQ (Bass, Middle, Treble), Phase switch (for the Anti-feedback), Master volume, Low battery LED with Piezo-Magnetic blender.

- The Phase switch has two functions, one is the Anti feedback switch and another is the phase reverse effect on Piezo channel.  

- Special character of ASE-BL is not only blending for the piezo and magnetic sound, but also Phase reverse effect on Piezo channel.

- When you push the phase switch to subtract(common mode reduce) the Piezo
and Magnetic phase,  you will have the light folk and crystal clean sound. In normal mode, Piezo and Magnetic phase will be 'add up' so you  can have the rich and warm sound while you are using blender.

- ASE-BL has very low battery drain rate.
The service hour is over 1000 hours in continuous use. (9V Alkaline battery)

- ASE-BL is well matched with MSP 50(Artec sound hole magnetic pickup)
 

ASE-BL  features :
- Bass, Middle,
  Treble Controls
- Blender control
- Master Volume
- Low  Battery check LED
- Piezo input jack
- Magnetic input jack

DIMENSION :
  W 50 X H 90 X D 40 (mm) 

Technical Specifications

MSP 50
Sound hole magnetic pickup

Nominal input level:
Frequency Response:
Input Impedance:
Output Impedance:
Power Supply:
Battery Life:
Bass control range:
Middle control range
Treble control range
Low  Battery:
Current Drain:
Input Jack:
Output Jack

-20 dBV
20 Hz - 20 kHz
10 MOhm
10 kOhm
9 V Alkaline Battery
over 1000 hours
Boost & Cut 12 dB 80 Hz, 570 mVp-p
Boost & Cut 12 dB 800 Hz, 490 mVp-p
Boost & Cut 12 dB 3 kHz, 500 mVp-p
Low Battery indicator at 4.5 V ~ 5.5 V
Less than 0.5 mA
2.5 mm Mono Jack
1/4" Phone Jack

ASE-CH   2 band EQ with Chorus Effect onboard

ASE-CH gives you the ability to create your own acoustic effects with your ordinary guitar.  Once you turn the Chorus switch on, you will experience a totally different acoustic atmosphere from any other equalizer system could provide.
Rich, Sweet and Melrose sound...

Simply control the 'SPEED' knob to establish an exquisite piece of guitar sounds for your performance.

 ASE-CH  features :
 - Bass, Treble Controls
 - Speed control, Master Volume, Low  Battery check LED
 - Chorus on/off switch

 DIMENSION :  W 50 X H 90 X D 40 (mm)

Attention!

- To avoid battery drain, be sure to unplug the output jack when not in use.
- Automatic Low Battery check LED
To check the battery power without operating a battery check switch.
When a cable is plugged into the output jack. Batt/Low LED will flash for 2 seconds to indicate that the power is on. The Batt/Low LED will stay on constantly when the battery power is lower than 4.5 V - 5.5 V after fully used. This function will alert that the sound is starting to be distorted. Therefore, Battery should be replaced immediately.