ATE Standard Series

 

 

ATE 4

It features a 4 band graphic equalizer - Bass, Middle, Treble & Presence - with Master volume and Low Battery check LED. Using metal case could eliminate unwanted noise and the slim body case could be fit in any size of guitars.

ATE-N

ATE-N is an advanced variation of ATE 4 with Notch filter control.

DIMENSION : W 50 X H 98 X D 40 (mm) 

ATE 4  features :
- Bass, Middle,
  Treble, Presence Controls
- Master Volume,
  Low  Battery check LED
 

ATE-N  features :
- Bass, Middle, Treble,
  Presence Controls
- Master Volume,
  Low   Battery check LED
- Notch switch

 

 

Technical Specifications

Nominal input level:
Frequency Response:
Input Impedance:
Output Impedance:
Power Supply:
Battery Life:
Bass control range:
Middle control range
Treble control range
Presence control range:
Low Battery:
Current Drain:
Input Jack:
Output Jack

 

-20 dBV
20 Hz - 20 kHz
10 MOhm
10 kOhm
9 V Alkaline Battery
over 1800 hours
Boost and Cut 12 dB 80 Hz, 570 mVp-p
Boost and Cut 12 dB 800 Hz, 490 mVp-p
Boost and Cut 12 dB 3 kHz, 500 mVp-p
Boost and Cut 12 dB 15 kHz, 500 mVp-p
Low  Battery check at 4.5 V ~ 5.5 V
Less  than 0.3 mA
2.5 mm Mono Jack
1/4" Phone Jack


ATE frequency characteristics. 

  Attention!
 

- To avoid battery drain, be sure to unplug the output jack when not in use.
- Automatic Low battery check LED
To check the battery power without operating a battery check switch.
When a cable is plugged into the output jack. Batt/Low LED will flash for 2 seconds to indicate that the power is on. The Batt/Low LED will stay on constantly when the battery power is lower than 4.5 V - 5.5 V after fully used. This function will alert that the sound is starting to be distorted. Therefore, Battery should be replaced immediately.